Filter
Top Products
User’s manual
350 - 1500 VA
8
1023922
Revision A
2. Normal mode (Green)LED
Indicates the UPS is providing mains power to your equipment. When the LED is
blinking the UPS is providing power from the battery.
3. Fault (Red)LED
When blinking, LED could indicate an overload condition or that the battery should
be replaced. When the LED is always on it indicates a short or UPS fault. For details
please see Indicator Table.
4. Battery mode (Yellow)LED
Indicates the UPS is providing battery power to your equipment.
5. Four Battery Backup & Surge Protection Outlets
These three outlets not only provide full time surge protection but also provide
emergency battery backup power.
6. Four Surge Protection Outlets
These Three outlets provide full time protection from surge and spike.
7. Phone/modem/ADSL Protection
Built-in RJ11 jacks protect the Internet, phone or fax line from surges. Connect the line
in from the wall into the jack named “in” and connect the phone, modem, ADSL box to
the jack named “out”
8. USB Communication Port
The provided LanSafe monitoring and shutdown software can be automatically
confi gured to save your fi les and shut down your computer in the event of a prolonged
power outage.
9. Circuit Breaker
The button will protrude when the overload condition occurs. The UPS will switch off
of utility power. If the button protrudes, disconnect some non-essential equipment and
reset the circuit breaker by pushing the button inward.
10. Input Power Connector IEC C13
Plug your load power cable to power your UPS