Filter
Top Products
E. Change the Unit of Measure between Metric and English.
The AP362 can display measurements in both centimeters and inches. Follow these steps to
switch between the two.
English (Inches):
1. Turn off the unit.
2. Press and hold both the "Mode" button and the "+" button while you switch on the unit.
3. While the unit is booting up a "-" will appear as the first digit of the firmware version
number on the display.
Metric (Centimeters):
1. Turn off the unit.
2. Press and hold both the "Mode" button and the "-" button while you switch on the unit.
3. While the unit is booting up a " " will appear as the first digit of the firmware version
number on the display.
F. Set the Mode of Container Roller Motor:
By default the container rollers continue to spin after every application. This is done to
increase application speeds. However, using this method it is not possible to apply the label
at a specific point on the container. To do this you can put the unit in Stop After Apply mode.
See the instructions below:
Run After Apply (Default):
1. Turn off the unit.
2. Press and hold the Recall button with the ‘+’ key and turn on the unit.
Stop After Apply:
1. Turn off the unit.
2. Press and hold the Recall button with the ‘-’ key and turn on the unit.
14 AP360/362 Label Applicator