Primera Technology AP360 Label Maker User Manual


 
Thank you for purchasing the AP360 or AP362 Label Applicator (hereafter referred to as "Label
Applicator"). Bottles, cans etc. will collectively be referred to as "containers." This manual applies
to two label applicator models. The AP362 has a Control Panel that allows you to count labels
and apply two labels to the same container. The AP360 does not have a Control Panel or two-label
capability.
The Label Applicator includes a Power Cord, 12 volt Power Adapter and the parts shown in
Figure 1-1. The Roll Bar, Roll Guides and Roll Drag Arm are located in the supply box along with
the Power Cord. You will need to assemble them as shown in Figure 1-1. Attach the Power Cord
and switch on the power as shown in Figure 1-2. Feed the Foot Switch and Foot Switch cord out
through the front of the Label Applicator. Remove the tape securing the Container Rollers.
Section 1: Unpacking and Setup
Figure 1-2.
Figure 1-1.
Roll Bar
Roll Guides
Label Sensor Flag
Label Sensor Bracket
Container Guides
Container Idler
Roller
Container Drive
Roller
Container Pressure Arm
Liner Idler Roller
Liner Drive Roller
Control Panel
(AP362 only)
Foot Switch
Peel Edge
Power Switch
Power Input 12V
Roll Bar
Roll Guides
Feed Area
(under grey bar)
AP360/362 Label Applicator 3
Power Cord
Roll Drag Arm
Power Adapter