Filter
Top Products
Optical Disc Laminator Connectivity Guide 5
5) From the Main Application Screen click Robotics then
Options.
6) Enable the Use Laminator checkbox.
7) Click the button labeled Move to (Calibrate). This will
move the Picker Mechanism to the Laminator Tray
position.
8) Lower the disc to the Laminator Tray Position as
follows:
a) Press and hold the Sequence and Pick buttons
simultaneously for 5 seconds to enter calibration
mode. The LEDs on the front of the
DuplicatorMAX will flash back and forth indicating
that the unit is in calibration mode.
Press Simultaneously
Until LEDs Toggle
510887.qxd 1/21/2004 7:35 PM Page 5
TOC