Filter
Top Products
CPCL Emulation
CPCL Emulation supports a subset of the Comtec CPCL command set and allows the Printek MtP Series
printers to respond to commands designed to control a CPCL compatible printer. The commands that are
supported are listed below.
Note: This emulation is only available in units with firmware version 2.0 or later.
CPCL Commands
Terminate and Print File PRINT
Form Feed FORM {max feed} {skip length}
Set Form Feed SETFF
Place Text on Label TEXT, T {font} {size} {x} {y} {data}
Place Text on Label, Rotated 90° CCW TEXT90, VTEXT, T90, VT {font} {size} {x} {y} {data}
Place Text on Label, Rotated 180° TEXT180, T180 {font} {size} {x} {y} {data}
Place Text on Label, Rotated 270° CCW TEXT270, T270 {font} {size} {x} {y} {data}
Place Mult. Same Size Text Lines on Label MULTILINE, ML {height}{text} {font} {size}
{x} {y} {data}
ENDMULTILINE, ENDML
Set Font Magnification SETMAG {w} {h}
Print Bar Code BARCODE, B {type*} {width} {ratio} {height}
{x} {y} {data}
Print Vertical Bar Code VBARCODE, VB {type*} {width} {ratio} {height}
{x} {y} {data}
Print PDF-417 Bar Code BARCODE PDF-417 {x} {y} [XD n] [YD n [C n] [S n] {data}
ENDPDF
Print Human Readable Text Under Bar Code BARCODE-TEXT, BT {font number} {font size} {offset}
Place a Rectangular Box on Label BOX {x0} {y0{ {x1} {y1} {width}
Place a Line on Label LINE, L {x0} {y0{ {x1} {y1} {width}
Place Expanded Graphics on Label EXPANDED-GRAPHICS, EG {width} {height}
{x} {y} {data}
Place Vertical Expanded Graphics on Label VEXPANDED-GRAPHICS, VEG {width} {height}
{x} {y} {data}
Place Compressed Graphics on Label COMPRESSED-GRAPHICS, CG {width} {height}
{x} {y} {data}
Place Vertical Compressed Graphics on Label VCOMPRESSED-GRAPHICS, VCG {width} {height}
{x} {y} {data}
Set Print Contrast Level CONTRAST {level}
Set Print Tone Level TONE {level}
Set Page Width PAGE-WIDTH,PW {width}
Enable Pace Mode PACE
Disable Pace Mode NO-PACE
Wait n/8 Seconds WAIT {delay-time}
Set Maximum Print Speed SPEED {speed level}
Set Paper Feed Distance Before Printing PREFEED {length}
Set Paper Feed Distance After Printing POSTFEED {length}
Position Media at Tear Bar for n/8 Seconds PRESENT-AT {length} {delay}
Sound Control Panel Bell for n/8 Seconds BEEP {beep length}
39