Filter
Top Products
Printek Emulation
Page 7-4
Character Size
Set Character Spacing ESC SP n
Sets character spacing in decipoints (n/720 of an inch). Overrides the "CPI:" value in
the "Setup: FORM" menu. Supported values are shown in the following table.
n Character Size
72 10 cpi
60 12 cpi
54 13.3 cpi
48 15 cpi
43 16.74 cpi
42 17.14 cpi
36 20 cpi
Example: The following escape sequence will select 10 cpi character spacing.
Escape Sequence: ESC SP 72
Hexadecimal: 1B 20 48
Double-Wide Mode ESC W n
Selects double-wide mode for n=1, or cancels for n=0. Double-wide mode doubles
the width of all characters, but does not affect character height. ESC S 3 may be used
to select double-high mode.
Example: The following escape sequence will select double-wide mode.
Escape Sequence: ESC W 1
Hexadecimal: 1B 57 31
Select Script Modes ESC S n
Selects normal character height for n=0, subscript mode for n=1, superscript mode for
n=2, or double-high mode for n=3. This is shown in the following table.
n Script Mode
0 Script modes off
1 Subscript
2 Superscript
3 Double high
Subscript mode will print characters about half the normal height in the bottom half
of the normal character cell. Superscript mode will print characters about half the
normal height in the top half of the normal character cell. Double-high mode doubles