Filter
Top Products
IBM Proprinter Emulation
Page 4-9
Select Print Mode ESC I n
Selects print mode n according to the following chart. Overrides the "Font:" value in
the "Setup: FORM" menu.
n Print Mode
0 Draft
1 Draft 12 cpi
2 Letter Quality
3 Letter Quality
Example: The following escape sequence will select the IBM Proprinter letter quality
font.
Escape Sequence: ESC I 3
Hexadecimal: 1B 49 03
Line Pitch
Select 8 LPI ESC 0
Sets the line spacing to 1/8 of an inch per line (8 lpi). Overrides the "LPI:" value in
the "Setup: FORM" menu.
Escape Sequence: ESC 0
Hexadecimal: 1B 30
Set Line Spacing to 7/72" ESC 1
Sets the line spacing to 7/72 of an inch per line. Since the distance between print
head wires is 1/72 of an inch, this is equivalent to setting seven wire spacing. This is
not particularly useful for text, but may be useful for graphics if 7-bit graphics data is
being sent. Overrides the "LPI:" value in the "Setup: FORM" menu.
Escape Sequence: ESC 1
Hexadecimal: 1B 31
Start Line Spacing ESC 2
Sets the line spacing to the value selected by ESC A n. Overrides the "LPI:" value in
the "Setup: FORM" menu.
Escape Sequence: ESC 2
Hexadecimal: 1B 32