Filter
Top Products
10
PREPARATION
PICTURE LEVEL AND TILT ADJUSTMENT
Picture tilt and projection angle can be adjusted with
handles on both sides of the projector. Projection angle
can be adjusted to 5.7 degrees upper way.
1
2
3
MOVING THE PROJECTOR
CAUTION IN CARRYING OR TRANSPORTING THE PROJECTOR
● Do not drop or bump the projector, otherwise damages or malfunctions may result.
● When carrying the projector, use a suitable carrying case.
● Do not transport the projector by using a courier or transport service in an unsuitable transport case. This
may cause damage to the projector. To transport the projector through a courier or transport service,
consult your dealer and best case should be applied.
For safety, be sure to hold Carrying Handles
on both sides by 2 or more people when
moving the projector. Moving it unproperly
may result in damage of cabinet or person's
injury.
Replace the lens cover and retract the feet to
prevent damage to the lens and cabinet.
1
2
3
Pull up the lock buttons on each side of carrying
handles and release the locks.
CARRYING
HANDLE
LOCK BUTTONS
Pull carrying handles out fully until it's locked (with a
click). Move the projector by holding two handles by 2 or
more people.
To retract carrying handles, pull up the lock buttons and
release the lock of handles and press the handles fully
in until it's locked.
LEVEL AND TILT
ADJUST HANDLE
ADJUSTABLE
FEET
The height of front feet can be
adjusted by turning the handles.
KNOB
Press the knob on the handle. The handle pop out.
Turn the handles (right and left) until the picture is
projected on proper position. Adjust height of rear
adjustable feet by rotating them until projector properly
stabled on the table.
Press knob and retract the handle.
REAR ADJUSTABLE
FEET. (Refer to P7).
Pull up the lock buttons
to release the lock.