Terminal Setup
This powerful software management tool is described in detail in Airloader Auto-
Configuration. For now, it is sufficient simply to use it for assignment of the initial
terminal configuration and IP address, both of which can be easily changed later. Ensure
that all of the check boxes are checked as shown above.
To assign terminal IP addresses automatically over the wireless network, check all of the
boxes as shown above. Then click on the
Addresses button and enter the desired range
in the
From and To boxes as shown in the following figure.
After setting the address range, click on
OK to return to the Airloader Auto-Configuration
screen.
Supported Equipment Manual
•
May, 2006
2-10