Part 19
to host whenever an off line status occurs. Therefore, signals including the
paper near end detect will generate busy signal to the host. Consequently, the
printing may be stopped even when there is still a long way to go before the
paper roll is actually exhausted. Taking the paper out beep into consideration,
the printer will keep on beeping at Paper End (completely no paper) till paper
is replaced when S1-5 is ON. Yet when S1-5 is OFF, the printer will keep on
beeping every 3 seconds at Paper Near End (still long paper in replace) till
paper is replaced.
For switch position 6, when it is set to OFF, there will be a 20 mm paper
feed before cutting when software does not define this point and there will be
further 10 mm paper after cutting to prevent paper jam. Before setting this
switch to ON, please make sure that your software will take care of enough
paper feed for the paper jam prevention issue.
For switch position 8, when it is set to ON in the field, the printer maybe
subject to unpredictable damages and must be strictly prevented.
The factory default for each position is listed below:
Switch Position 1 2 3 4 5 6 7 8
Serial interface w/
auto cutter
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Parallel interface w/
auto cutter
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
USB interface w/ auto
cutter
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
LAN
interface w/ auto
cutter
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
INTERNAL SWITCH
There is an extra internal 4 position DIP switch in PP-7000II series for
more technical settings. To access these setup, please first turn off the printer
power and disconnect every cable from the printer. Remove 4 screws from
bottom of printer and remove the plastic bottom cover with the power switch
pressed. The 4 position DIP switch seats beside the 8 position DIP switch for
setup window with the switch position counting starts from the nearest side to
the 8 position DIP switch.
This 4 position DIP switch works as following:
Switch position Setting Effect
ê
Function ON OFF
1
Factory internal setting
Disable Default
2
Paper width 58 mm 80 mm
3
Line format 576 dots / line 512 dots / line
4
Reserved N. A. N. A.