Filter
Top Products
Part 8
Use the normal USB Cable (P/N: 21863250800) to connect to a
normal USB port or the normal USB portion of the powered USB connector of
host system. The power adaptor is required in this normal USB application.
Use the powered USB cable to connect a +24V Powered USB port of Posiflex
POS system with the powered USB plug, and connect to the USB port in PP-
7000U/7200U with the type B normal USB plug and the 3-PIN power plug to
the 3-PIN power jack in PP-7000U/PP-7200U. The power adaptor can be
deleted in this powered USB application. Please always press the locking strap
first before disconnecting the Powered USB cable. Please visit our web site
http://www.posiflex.com or http://www.posiflex.com.tw for detailed
information of the USB driver installation if required. Set in setup window the
same way as in serial connection, i.e. switch positions both 1, and 2 to OFF
leaving the rest unchanged as factory default setting.
Peripheral Connection
The peripheral controller is a 6 pin RJ11 type modular jack. With use
of Posiflex cash drawer cable 21863018010 (CCBLA-180-1) come with cash
drawer, this port can control a Posiflex cash drawer CR3100 or CR3200 or
CR4000 or CR4100 or CR-6310. If a Posiflex special split cable 21863023800
(CCBLA-238) is used instead, this port can control two cash drawers of above
models.
When the printer is used as a kitchen printer, please use this port for
kitchen bell connection instead.
Power Connection
The power connector is a 3-PIN jack between the peripheral
connector and the parallel connector for PP-7000II or between the peripheral
connector and the B type USB connector for PP-7200U and is at the rightmost
for PP-7000U & PP-7200L. Either a Posiflex supplied power adaptor or a
printer power cable from a Posiflex POS system can be connected to this
connector to supply power for this printer. During insertion of the power plug,
be sure to hear the click to obtain a firm contact.
CAUTION: Before doing the insertion or extraction of the power plug, be
sure to pull the outer sleeve of the plug backward to release the
internal latch. Failure to do this could damage the power plug. Such
damage is considered as an artificial destruction and is not covered
by the warranty.