Filter
Top Products
2
Step 3. Install SFPs
An SFP transceiver is required for each switch port that will be connected to a device, device loop, or another switch.
❑ To install an SFP transceiver, insert the transceiver into the switch port and gently press until it snaps in place. The
transceiver will fit only one way. If the transceiver does not install under gentle pressure, flip it over and try again.
Step 4. Apply Power to the Switch
❑ Connect the external DC power supply to the back of
the switch.
❑ Attach the AC power cord to the external power supply
and wall outlet or power strip. Verify that the Input
Power LED is illuminated.
❑ The switch runs its self tests and begins normal
operation – this may take a few minutes. Verify that
the Heartbeat LED is blinking (once per second) and
the System Fault LED is NOT illuminated.
Step 5. Verify Workstation Requirements
❑ Verify that your workstation can support the SANsurfer Switch Manager™ application with the following minimum
requirements:
❑ Windows XP/2000/2003
❑ 256 MB memory
❑ 150 MB disk space
❑ 500 MHz processor
❑ Video card with 256 colors
❑ CD ROM drive, RJ-45 Ethernet port
❑ Internet Browser: Microsoft® Internet Explorer®, Netscape Navigator®, Mozilla™
SYSTEM
FAULT LED
INPUT
POWER
LED
HEARTBEAT
LED