Q-Logic 9000 Network Hardware User Manual


 
5
Step 7. Connect the Workstation to the Switch
Connect the CPU0 blade Ethernet port directly to the workstation using an Ethernet cable, or indirectly through a
switch or hub. The Ethernet port automatically discovers straight and cross-over cables. You must have a live
Ethernet connection when the workstation powers up.
NOTE: The Maintenance Panel Ethernet ports on the front of the switch are disabled and should not be used for the
initial installation. You can enable the Maintenance Panel Ethernet ports after the switch is operational.
Step 8. Install Enterprise Fabric Suite 2007
The Enterprise Fabric Suite 2007 application includes the Configuration Wizard. This wizard auto-detects and configures
the switch based on selected options and recommended settings. To download and install the
Enterprise Fabric Suite 2007 application on a Windows workstation/server, perform the following steps:t
1. Insert the Enterprise Fabric Suite 2007 disk into the CDROM drive.
2. In the upper left corner of the product introduct screen, click Management Software.
3. Click Install for Windows 2003, XP.
4. Enter the serial number and license key provided to activate the Enterprise Fabric Suite 2007
application.
Step 9. Obtain Network Configuration
Obtain the IP address and subnet mask from your network administrator. Be sure that your workstation is configured
for the same subnet.
CPU0 BLADE
ETHERNET PORT