Filter
Top Products
A – Fast!UTIL Configuration Settings
FC2251101-00 D A-3
Some new system BIOSs support selectable boot, which supersedes the Fast!UTIL
selectable boot setting. To boot from an FC hard disk attached to the QLA23xx
board, select the QLA23xx board FC hard disk on the system BIOS.
NOTE: This option applies only to hard disks; it does not apply to tape drives and
other nondisk devices.
A.2.3
Restore Default Settings
The Restore Defaults option from the Configuration Settings menu restores the
QLA23xx board default settings.
A.2.4
Raw NVRAM Data
This option displays the adapter’s NVRAM contents in hexadecimal format. This is
a QLogic troubleshooting tool; you cannot modify the data.
A.2.5
Advanced Adapter Settings
From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter
Settings. The default settings for the QLA23xx board are listed in table A-2 and
described in the following paragraphs.
Table A-2. Advanced Adapter Settings
Setting Options Default
Execution Throttle 1–256 16
Fast Command Posting Enabled, Disabled Disabled
>4GByte Addressing Enabled, Disabled Disabled
Luns per Target 0, 8, 16, 32, 64, 128, 256 8
Enable LIP Reset Yes, No No
Enable LIP Full Login Yes, No Yes
Enable Target Reset Yes, No No
Login Retry Count 0–255 8
Port Down Retry Count 0–255 8
Drivers Load RISC Code Enabled, Disabled Enabled
Enable Database Updates Yes, No No
Disable Database Load Yes, No No
IOCB Allocation 1–512 buffers 256 buffers
Extended Error Logging Enabled, Disabled Disabled