Filter
Top Products
4
❑ The correct connectors:
❑ QLA4050: LC duplex
❑ QLA4050C/4052C, QLE4060C/4062C: RJ45
Step 1. Verify the Package Contents
The QLogic host bus adapter is shipped with the following items:
❑ QLogic SANblade host bus adapter
❑ Low-profile bracket (not available in all models)
❑ Quick Start Guide (this document)
❑ SANsurfer
®
for SANblade iSCSI HBAs CD(s)
Step 2. Install the Host Bus Adapter Hardware
NOTE: When installing the QLogic host bus adapter and driver in a Solaris system that does not already have QLogic
host bus adapters or drivers installed, please install the QLogic Solaris driver before you install the QLogic host bus
adapter hardware. This allows Solaris to correctly bind the QLogic Solaris driver to the QLogic host bus adapter. Failure
to do so will require an additional system reboot after the driver is loaded.
To install the host bus adapter hardware, you need to open the computer and locate the appropriate bus slot. If necessary,
consult your computer system manual for instructions to remove the computer cover.
Depending on the host bus adapter you are installing, the bus connector will look like one of the following samples:
PCI-X PCI Express
Optical
QLA4050 N/A
Copper
QLA4050C QLE4060C
QLA4052C QLE4062C