Filter
Top Products
Quantum Scalar 50 Tape Drive Installation Instructions
Document 81-81769-01 B01
September 2007
Completing the Native Fibre Channel Installation 19
• Connect Via a Web Browser
Connect Via a Telnet Session 0
To connect via a Telnet session to a SAN switch:
1 Connect the service laptop to the SAN switch using an Ethernet cross-
over cable, or by connecting to the LAN (if available).
2 On the service laptop, open a command prompt window.
3 From the command prompt, enter the following command and press
<Enter>:
telnet <IP address of SAN switch>
The SAN switch login prompt displays.
4 Enter the
username and password and press <Enter>.
5 For Brocade switches, at the command prompt, type
nsshow and press
<Enter>.
The nsshow command displays (see figure 21
).
Figure 21 Nsshow
Command
Note: The information below applies to a Brocade SAN switch. For other
SAN switches, contact the SAN administrator.
Note: For Brocade SAN switches, the default login is admin for the
username and
password for password. This may have been
changed by the system administrator. For all other switches,
contact the system administrator.
WWN for the first
Native Fibre channel
drive
WWN for the second
Native Fibre channel
drive
WWN for the library