Filter
Top Products
Chapter 5 ATAPI Interface
Page 80 Seagate Travan 40 Product Manual
REWIND (Group 0, Op Code 01)
When operating in single partition mode, the REWIND command causes the drive to
rewind the tape to the physical Beginning-Of-Partition (BOP) or load point.
CDB for REWIND command
Data Bits
Byte 7 6 5 4 3 2 1 0 Hex
0 0 0 0 0 0 0 0 1 01
1 0 0 0 0 0 0 0 IMM 0X
2 0 0 0 0 0 0 0 0 00
3 0 0 0 0 0 0 0 0 00
4 0 0 0 0 0 0 0 0 00
5 0 0 0 0 0 0 0 0 00
IMM—Immediate: Not applicable for ATAPI drives
Application Note: When Writing in Buffered Mode, the target shall discard any
buffered data after a REWIND command is validated if the previous command was
terminated with a Check Condition status, and the drive is unable to write the data to
tape (as when a “hard” write error occurred).