Filter
Top Products
2. Installation
If the default address and interrupt settings are sufficient, the DS-100 can be quickly installed and
put to use. The factory defaults are listed in Figure 1.
YES32F8 hexSerial 1
YES43F8 hexSerial 0
ENABLEDIRQADDRESSPORT
Figure 1 --- Default address and IRQ settings for DS-100
The output of the DS-100 is two 9-pin D-connectors labeled CN1 (serial 0) and CN2 (serial 1).
1. If the default settings are correct, skip to step 2, otherwise refer to sections 4 and 5 of this
document for detailed information on how to set the address and IRQ level.
2. Turn off the power of the computer system in which the DS-100 is to be installed.
3. Remove the system cover according to the instructions provided by the computer
manufacturer.
4. Install the DS-100 in any vacant expansion slot. The board should be secured by
installing the Option Retaining Bracket (ORB) screw.
5. Replace the system cover according to the instructions provided by the computer
manufacturer.
6. Attach and secure the cable connectors to the desired equipment.
2-1 Quatech Inc.