Filter
Top Products
II. INSTALLATION
If the default address and interrupt settings are sufficient, the
DS-102 can be quickly installed and put to use. The factory defaults are
listed in Figure 1.
YES
3
2F8 hex
(COM2)
Serial 2
YES
4
3F8 hex
(COM1)
Serial 1
ENABLED ?
IRQ
ADDRESS
PORT
Figure 1 --- Default address and IRQ settings for DS-102
The serial port outputs on the DS-102 are CN1 and CN2, which are
shielded D-9 connectors. Serial 1 is available on CN1 and Serial 2 is
available on CN2.
1. If the default settings are correct, skip to step 2, otherwise refer to
sections III and IV of this document for detailed information on
how to set the address and IRQ level for each port, and for how to
disable or enable each port.
2. Turn off the power of the computer system in which the DS-102 is
to be installed.
3. Remove the system cover according to the instructions provided by
the computer manufacturer.
4. Install the DS-102 in any vacant expansion slot. The board should
be secured by installing the Option Retaining Bracket (ORB) screw.
5. Replace the system cover according to the instructions provided by
the computer manufacturer.
6. Attach and secure the D-9 connectors to the desired equipment.
2
Quatech
DS-102 User's Manual