Filter
Top Products
2. DOS / Windows 3.x Installation
Two configuration software programs are provided with the QSP-100: a Client Driver,
QSP100CL.SYS, and a card Enabler, QSP100EN.EXE. Both of these programs are executed
from DOS (before entering Windows) and allow operation of the QSP-100 in both the DOS and
Windows 3.x environments. For optimal operation, however, the Client Driver is the preferred
method of installation and configuration. The table below highlights the differences between
these programs.
Does not require PCMCIA Card and
Socket Services software
Requires PCMCIA Card and Socket
Services software
Does not support automatic configura-
tion of QSP-100 adapters upon insertion
(Hot Swapping)
Allows automatic configuration of
QSP-100 adapters upon insertion (Hot
Swapping)
Interfaces directly to Intel 82365SL and
other PCIC compatible PCMCIA host
adapters
Interfaces to PCMCIA Card and Socket
Services software (PCMCIA host adapter
independent)
File type: DOS executableFile type: DOS device driver
File name: QSP100EN.EXEFile name: QSP100CL.SYS
Enabler
(not recommended)Client Driver (recommended)
Figure 1. Client Driver versus Enabler for DOS/Windows 3.x.
Card and Socket Services software is commercially available from several vendors for most
desktop and laptop PCs. If you are unsure whether Card and Socket Services software is
currently installed on your system, install the QSP-100 Client Driver as discussed in following
section. When loaded, the Client Driver will display an error message if Card and Socket
Services software is not detected.
QSP-100 Users Manual 5