Filter
Top Products
10 MASTERCONSOLE II USER MANUAL
d. The Channel ID and Name will be displayed on the screen for the time interval specified in the
Configuration Menu.
2. To activate AutoScan, press the [Scan] button (toggle ON/OFF) The green light next to the [Scan]
button will be ON and the unit will scan according to the parameters set in the Configuration Menu. If
the AutoScan Mode is set to Individual, AutoScan will occur at the Channel-Specific Scan Rates as
defined in the Edit Names and Scan Rate Menu.
3. To change the scan rate, while AutoScan is ON, press the numbered button corresponding to the
desired Scan Rate located above the front panel channel light to set the Global Scan Rate. If the Scan
Mode in the Configuration Menu had been previously set to Individual, it will be reset to Global after
the front panel button is pressed.
4. To activate AutoSkip, press the [Skip] button (toggle ON/OFF). The green light next to the [Skip]
button will be ON and only active channels will be selected.