Filter
Top Products
91
8. Troubleshooting
SCSI Configuration Utility Window
[PCI Burst Mode]
Default is Enable. If the PC does not support PCI Burst Mode, check the Disable button.
[Parity]
Default is Enable. If you connect the device which does not have parity check function, check the Disable
button.
[Host SCSI ID]
SCSI ID No. for the CB31U. Default is 7. If you connect the device which can be not assigned other than
7, change the ID.
[Disconnect]
Default is ON (checked) at all IDs. In case of ON, the device is disconnected from SCSI bus temporarily.
While the device is disconnected, the SCSI PC Card can run other functions on the SCSI bus efficiently.
[Command Queuing]
Default is ON (checked). If the queuing is required, check Queuing ID and enable Disconnect function.
[Translation]
Default is 20MB/s. Select the transfer rate by trying the choices shown until you find one that is successful.
If you connect FUJITSU MO(M2512A, M2513A), select 10MB/sec.
If you connect the asynchronous device, select Async.