Filter
Top Products
5.2 DIP Switch Settings
On the rear on the unit, you’ll find four active DIP Switches. The selections are:
SW1: OFF = Auto-Detect Off, Default NTSC, ON = Auto-Detect NTSC or PAL
SW2 + SW3: PC Operating System
SW2 SW3 Setting
OFF OFF DV Camcorder
OFF On WIN 2K/WIN XP
On Off WIN 98/WIN ME
SW4: = Off 7.5 IRE, On = 0 IRE Setup (NTSC Only)
If you have a clean input and the input is a valid format, the unit should begin
conversion of the signal as soon as you have the proper selections made. No
adjustments are required to enable signal conversion beyond those explained
above.
5.3 Hardware Installation And Check Out
Follow the instructions below to install and checkout the hardware.
5.3.1 Hardware Installation
• Connect the AVT-2050’s A/C Power adapter and press the power button.
• Connect the 6 Pin 1394 cable between the AVT-2050 and computer.
Note: Connect directly to the 1394 Host port. Connecting via a 1394 Hub or
Repeater is not recommended.
• WinXP and Win2000 will automatically recognize the device and install.
drivers. WinME and Win98SE may ask for drivers from the Windows CD.
• Once the device drivers are installed, the AVT-2050 will appear under
Windows Device manager as an Imaging Device.
• Connect Audio/Video cables between your video devices and AVT-2050.
9