Filter
Top Products
6
1. Plug Extension Unit into an electrical outlet near your computer
CPU. Do not plug into power strip or surge protector.
2. Unplug telephone from the extension unit if used to test for
dial-tone.
3. Plug telephone line cord from the computer modem jack into
the jack on the side of the Wireless Modem Jack Extension
Unit.
4. Your computer modem is now ready to operate.
Under certain circumstances where static is present in your
telephone line, the Wireless Modem Jack may not filter or remove
such static. This condition can affect computer modem
performance. Try installing the base unit and or the extension unit
in another electrical outlet.
Security Programming
Once steps 1-5 have been completed in the installation sequence
above, and the units have been installed and connected to the set-
top-box, you can now set the security. Follow the easy steps below to
set the security feature for the units.
1.Using a small pointed object,
press the black recessed button
on the side of the base unit. The
green light on the lower front
right hand corner of the base unit
will come on. This will stay lit
during the security programming
sequence. Once the button is pressed, you now have (5) minutes
to program your first extension unit.
2. Now press the black recessed
button on the side of the
extension unit. The green light in
the lower front right hand corner
of the extension unit will flash
once. Programming of that unit
is now complete. (If the green
button is flashing repeatedly, your base unit is not in
programming mode. You will need to go back to step one.)