Filter
Top Products
Direct Drive LCD Design Guide
3.2 Hardware Design
Below is a block diagram of a LCD system which uses Flash and SRAM for respectively storing and
buffering the images to be displayed.
The following table describes the TPU channels and pins used for direct drive. Note that the TPU
synchronization capability is used to create a common time base between the HDEN, HSYNC and
VSYNC pins.
Signal TPU Channel Requirements
Suggested
Channel
DOTCLK Output using PWM 1 Mode 1, 2, 4 or 5
DOTPER TGR to set period of DOTCLK same as DOTCLK
HDEN Output using PWM 2 Mode 1, 2, 4 or 5
HDEN2 TGR for PWM 2 Mode same as HDEN
HSYNC Output using PWM 1 Mode 0 or 3
VSYNC Output using PWM 1 Mode same as HSYNC
HPER TGR to set horizontal period same as HSYNC
Figure 9 Block Diagram
Note 1:
Dot Clock Logic
Note 2: Touch Screen
14