Filter
Top Products
4
PREPARATION
Using AC Power
You can power the PA system using
the supplied AC cord.
Cautions:
The cord’s plug must fit
the system's
~120V AC
60Hz 60W
jack. The sup-
plied cord meets these specifica-
tions. Using a cord that does not
meet these specifications could
damage the system or the AC
cord. You can order a replace-
ment cord through your local Ra-
dioShack store.
• Always connect the AC cord to
the system before you connect it
to AC power. When you finish,
disconnect the cord from AC
power before you disconnect it
from the system.
Set the amplifier to
OFF
. Plug the
power cord’s plug into the amplifier’s
~120V AC 60Hz 60W
jack. Then plug
the other end of the cord into a stan-
dard AC outlet.
Caution: The supplied power
cord has a polarized plug that fits
into the outlet only one way. If the
plug does not fit properly, turn it
over and try again. Do not force
it.
Using Vehicle Battery Power
You can power the PA system from a
vehicle’s 12V power source (such as
a cigarette-lighter socket) using the
supplied DC cord.
Cautions:
You must use a power
source that supplies 12V
DC and delivers at least
2500 mA. Its plug must fit the
system's
DC 14.4V/2.5A
jack. The
supplied adapter meets these
specifications. Using a cord that
does not meet these specifica-
tions could damage the system or
the adapter.
• Always connect the cord to the
system before you connect it to
the power source. When you fin-
ish, disconnect the DC cord from
the power source before you dis-
connect it from the system.
Set the amplifier to
OFF
. Plug the DC
power cord’s barrel
plug into the
DC
14.4V/2.5A
jack.
Then plug the other
end of the cord into
a standard DC source such as an au-
tomobile 12V accessory outlet.
!
!
32-1245.fm Page 4 Tuesday, March 7, 2000 1:14 PM