Replace Maintenance Kit
10
1
Replacing the Fusing Unit
R
CAUTION:
A
AA
A
If the rear cover is attached to the
printer, remove it.
Note
❒ Proceed to step
B
if the optional
Duplex Unit was removed in
step
A
, "Replacing the Paper
Feed Rollers".
A Place a finger in the printer's
rear cover finger hole (upper
center) and pull it open.
B Remove the rear cover in a hor-
izontal direction.
B
BB
B
Lift the lock levers of the fusing
unit as shown in the illustration.
C
CC
C
Pull the fusing unit out.
D
DD
D
Pull out the pins on both sides of
the new fusing unit.
• The fusing unit becomes very
hot. When installing the new fus-
ing unit, turn off the printer and
wait about an hour. After that, in-
stall the new fusing unit. Not
waiting for the unit to cool down
can result in a burn.
ZKEX210E
ZKEX220E
ZKEX222E
ZKEX223E
ZKEM010E
CassisP1GBmaintenance-F2_FM.book Page 10 Friday, May 23, 2003 10:04 AM