Filter
Top Products
SP 1000S
- 12 -
2 - Installation
Packaging contents
The packaging contains the items listed below:
Multifunction device
1 toner cartridge
1 installation guide and 1 PC installation CD ROM
1 Safety Guide, Command Guide (For Europe only)
1 power cord
1 USB cord
Device installation
1 Unpack the device.
2 Install the device respecting the security notices
stated at the beginning of this booklet.
3 Remove all stickers from the machine.
4 Remove the plastic protection film from the screen.
Loading paper
Loading paper in the paper tray
(1) Paper to be used must be inserted face down, and
abutting the side fence and back fence. Not abutting
the paper may cause feed failure, skewing or paper
jams.
(2) Amount of loaded paper must not exceed the loading
mark. If the loading mark is exceeded, this may cause
feed failure, skewing, or paper jams.
(3) Adding paper to the pile may cause double feeding,
and should be avoided.
(4) When withdrawing the cassette from the main unit,
always hold it with both hands.
Handling of paper
(1) Curling must be corrected before loading.
(2) Curls must not exceed 10 mm.
(3) Care must be taken with storage to prevent feed faults
and image defects due to leaving the paper in
conditions of high humidity.
Adding paper to the pile, or splitting the pile may cause
feeding problems, and must be avoided.
Humidity control
(1) Paper which has become damp, or paper which has
been left unused for a very long time, must not be
used.
(2) After opening the paper, it must be kept in a plastic
bag.
(3) Paper with waved ends, paper which is creased, paper
with crumples, and any other non-normal paper must
not be used.
Handling the unit
Operator shocks
During printing, shocks must not be applied to the paper
feed cassette, tray, cover, and other parts of the machine.
Moving the unit
When moving the unit on a desk, it must be lifted, and not
dragged.
Handling the Toner Cartridge
(1) Must not be stood on the side, or held upside down.
(2) Must not be shaken strongly.