Filter
Top Products
The address will be detected by the printer.
9. Press the [Menu] key.
10. If you are requested to restart the printer, turn off the printer, and then turn it back on.
11. Print a configuration page to confirm the settings made.
• For details about printing the configuration page using control panel, see p.35 "Test Printing".
Setting the Ethernet Speed
You can set the speed that the printer will use for Ethernet communication. For normal usage, the default
setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected
interfaces to automatically determine the optimum speed that they will communicate at.
Router/HUB Printer
[10Mbps
Half D.]
[10Mbps Full
D.]
[100Mbps
Half D.]
[100Mbps
Full D.]
[Auto Select]
10Mbps Half
Duplex
10Mbps Full
Duplex
100Mbps Half
Duplex
100Mbps Full
Duplex
auto-
negotiation
(auto selection)
• Connection cannot be established if the selected Ethernet speed does not match your network's
transmission speed.
• The use of this feature is recommended. To use it, select [Auto Select].
Ethernet Configuration
51