Filter
Top Products
Copyright Rose Electronics 2007. All rights reserved.
No part of this publication may be reproduced, stored in a retrieval system, or transcribed in any form or any
means, electronic or mechanical, including photocopying and recording, without the prior written permission of
Rose Electronics.
Rose Electronics Part # QS-UME
Printed In the United States of America
Keyboard commands
The following table describes the available keyboard commands. The [Ctrl] key
sequence is a press and release of the left control key. Commands following
[Ctrl] must be entered within 2 seconds.
Command
Key sequence
Description
Main Menu
[Ctrl] [F12]
Displays main menu
CPU List
[Ctrl] [Esc]
Displays CPU selection list
Direct CPU
connect
[Ctrl] n [Enter]
Connects directly to the specific
CPU number “n”.
Connect
Back
[Ctrl] [Backspace]
Connects to the previous CPU
Connect
Down
[Ctrl] [Minus sign]
Connects to the previous CPU
in a Group.
Connect Up
[Ctrl] [Plus sign]
Connects to the next sequential
CPU in a group
KVM Status
[Ctrl] D
Displays / Removes status box.
Logout
[Ctrl] L
Logs user out if the KVM station
is configured for user logins.
Disconnect
[Ctrl] Q
Disconnects the current CPU
Reset
Keyboard/
mouse
[Ctrl] R
Resets / enables keyboard and
mouse; enables PS/2 mouse on
connected CPU
Send Null
Byte
[Ctrl] N
Sends a null byte to the CPU’s
PS/2 mouse port. Use this
command if the PS/2 mouse
gets “out of sync”.
Reset Mouse
(NT or Unix
systems only)
[Ctrl] O (not zero)
Resets the currently selected
NT or Unix computers PS/2
mouse. Also switches the NT
mouse driver to “wheel” mode.
Start Scan
[Ctrl] S
Sequentially steps through all
connected CPUs in a group.
Stop Scan
[Ctrl] X
Turns scan “Off”
Table 1 - Keyboard Commands