Filter
Top Products
Step 3. Driver install
1. Insert the driver CD into your CD-ROM player
2. It is a auto-run disk, following the installation guide and finish the process.
3. If you stop the auto-run function, please run the “setup.exe” file in the
disk.
Connect the mouse with the receiver
This RF wireless LASER mouse provides multi radio channels and
different ID codes to avoid interference with other users of wireless
mice. Before using the wireless mouse, you must ensure that the same
channel & ID are set for the mouse and its receiver.
Please follow the steps as below to set up:
1. Establish communication between the receiver and the mouse
(Select identification codes).
y Press and release the connect button on the receiver.
y Press and release the “connect” button on bottom of the
wireless mouse, within 6 seconds.
y After above “connect” procedure, the same ID is selected on
both of the receiver and the mouse.
y Please move the mouse to operate its cursor. If there is
problem, please do the connecting setting procedure again or
check the trouble shooting guide.