Filter
Top Products
2 Port eSATA II Express Card RC605 User Manual
1. Follow Microsoft’s Windows installation procedure.
2. Restart the computer when prompted by Windows’ installation.
3. At the Windows Setup screen, press F6 to install the driver.
4. When prompted, press S to specify the location of the driver.
5. Insert the floppy disk, then press Enter.
6. Select Silicon Image SiI 3132 SATALink Controller for Windows XP/Server 2003, then press Enter.
7. Press Enter to finish driver installation, then follow the on-screen instructions to complete the Windows installation.
For An Existing Installation
1. At the Found New Hardware Wizard:
XP(w/SP1 or earlier)/Server 2003: continue to step #2
XP(w/SP2 or later)/Server 2003(w/SP1 or later): select No, not this time, then click Next.
2. Please insert the CD driver bound with eSATA II 300 2-Port ExpressCard into your CD-ROM Drive, select Install the software
automatically (Recommended), and click Next.
3. Accept the default entry, then click Next.
4. Click Finish.
5. Restart Windows to complete the installation.
For Windows® Vista
For New Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the
“ExpressCard\2-SATA\SATA” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
1. Follow Microsoft’s Windows installation procedure.
2. Restart the computer when prompted by Windows’ installation.
3. At the Windows Setup screen, press Load Driver to install the driver.
4. Insert the floppy disk, please select Silicon Image SiI 3132 SATALink Controller(A:\SI3132.INF), then press Next. (Change A:\ to
match your floppy drive letter)
5. Follow the on-screen instructions to complete the Windows installation.
For An Existing Installation
1. At the Found New Hardware Wizard window pop-up, please select Locate and install drier software (recommended) to start the
installation.
2. Please insert the CD driver bound with eSATA II 300 2-Port ExpressCard into your CD-ROM Drive.
3. Click on Close to complete the driver installation.
4. Restart Windows to complete the installation.
For Windows® 2000
For A New Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the
“ExpressCard\2-SATA\SATA” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
1. Follow Windows® 2000 installation procedure.