Filter
Top Products
2 Port eSATA II Express Card RC605 User Manual
2. Restart the computer when prompted by the installation.
3. At the Windows® 2000 Setup screen, press F6 to install the driver.
4. When prompted, press S to specify the location of the driver.
5. Insert the floppy disk, then press Enter.
6. Select Silicon Image SiI 3132 SATALink Controller for Windows 2000, then press Enter.
7. Press Enter again to finish driver installation, then follow the on-screen instructions to complete the Windows installation.
For An Existing Installation
1. At Found New Hardware Wizard, click Next.
2. Select Search for a suitable driver for my device (recommended), then click Next.
3. Please insert the CD driver bound with eSATA II 300 2-Port ExpressCard into your CD-ROM Drive, check CD-ROM drives, uncheck
the other boxes, click Next, then click Next again.
4. If the Digital Signature Not Found message appears, click Yes. Our driver has been thoroughly tested for stability and compatibility.
5. Click Next, then Finish.
6. Restart Windows to complete the installation.
To Verify Windows® Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
Double click SCSI and RAID Controller, then double click Silicon Image SiI 3132 SATALink Controller to display driver properties. A
message this device is working properly is displayed in the dialog box, the driver has been correctly installed.
Hot-Plugging Hard Disk Drives
To remove a drive from a powered up system, do the following:
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Click Disk Drives, right click the target disk and select Disable/Enable.
4. You can now remove the target disk.
Thank you for purchasing a quality Rosewill Product.
Please register your product at : www.rosewill.com for complete warranty information and future support for your product.