Filter
Top Products
User ManualVGA to HDMI Adapter RCAD-11001
2
Computer Composite Cable VGA to HDMI HDMI Cable TV or Monitor
Adapter
Installation
1. Connect the VGA only end of cable to VGA port on the computer/laptop.
2. Connect the included Audio cable to the audio out port on the computer
3. Connect Pig-Tail end of VGA cable to Rosewill VGA to HDMI Adapter unit.
4. Connect the USB cable to USB port on the computer (for power purpose)
5. Connect the HDMI port to TV or monitor, and other end to Cable to HDMI unit.
6. See picture below for correct installation.
Set Up
1. You can hot plug for installation. After you connect the unit correctly, you should
see blue LED on the unit flashing. That means units is powered but not yet sync
with HDMI. (If you see solid blue LED and no screen on the TV probably means
your TV doesn’t support that resolution you choose. Please check TV manual for
what resolution it supports.)
2. Right click mouse on the Window screen and choose “Screen Resolution” or
“Display Property” you will see a screen like this.
Please select 1024x768 to make sure this unit running properly. Please wait for
few second before signal sync with HDMI TV or monitor (Because some of the
notebook can’t send out certain resolution signals due to graphic card issues but
almost 100% of them support 1024X768. If you can see the screen then the blue
LED on the unit will led up solid. If you see blank screen but blue LED is solid that
means your monitor or TV probably don’t support that resolution you choose.)
After it works with 1024x768 then you can choose whatever you prefer for your
resolutions unless your TV or PC can not support.