Filter
Top Products
4
User Manual
SATA or IDE 3-in-1 (5.25”, 3.5”, 2.5”)to USB2.0 Cable Converter Adapter RCW608
After your finish this initialization process the drives will then be ready to use. Again, every system
is slightly different especially when it comes to RAID and RAID levels. Read the documentation
carefully before putting important data on your system.
Most operating systems include the necessary USB drivers that support hard drives, CD, DVD,
and Floppy Drives. These drivers must be installed for the Cable Adapter to work properly. If they
are not installed use the original installation disks to install the needed USB drivers. If you are
using USB 1.1 expect slow performance because of the limited speed of this bus.
Specifications
• Compliance with Gen1i of Serial ATA II Electrical Specification 1.0
• Support SATA Spread-Spectrum Clock
• Support SATA II Asynchronous Signal Recovery (Hot Plug) feature
• Compliance with USB 2.0 electrical specification
• Support USB High-Speed and Full-Speed Operation
• Compliance with USB Mass Storage Class, Bulk-Only Transport Specification
• Support ATA/ATAPI PACKET command set
• Support ATA/ATAPI LBA48 addressing mode
• Support 12MHz external crystal
• Support external NVRAM for Vender Specific VID/PID, Manufacture,
Product String of USB Device Controller