Filter
Top Products
8
User Manual
SATA or IDE 3-in-1 (5.25”, 3.5”, 2.5”)to USB2.0 Cable Converter Adapter RCW608
4. Plug the power adapter to power source and turn on the power
(Please make sure the voltage is between 100~240V)
5. Plug the USB2.0 cable to PC and wait for PC auto-detection.
Driver is needed only in old system such as Windows 98.
Please inset the driver disk when your system can’t complete
the installation process. Windows will auto-install after it detects
the driver disk and choose the most suitable driver for your system.
(Please notice the direction of USB port)
Notification
1. Please take off your ATA / ATAPI / SATA device from RCW-608 only after you turn off the
power to avoid any damage.
2. If you plug RCW-608 and hard drive to PC, PC might freeze during the beginning of booting.
In this case, you may unplug RCW-608 at the start of booting and re-plug it after PC enters
windows.
3. If PC can’t detect RCW-608 and hard drive in your OS, please try the following steps.
1. Unplug RCW-608 and try to reboot the PC.
2. Re-plug it after system enters the OS.
3. If all above still can’t help, it might be caused by the incompatibility between hard drive,
system and controller chipset. Please contact us for furthur support.