Royal Sovereign Laminator Laminator User Manual


 
1413
RSL-2702
9.2. COLD LAMINATING
1. Put cold roll film on upper shaft. Load backing paper on the lower shaft as per
illustration 6.2 on page 7.
2. Pull COLD film and fix it so that the Release Liner can be wound on take-up
mandrel clockwise. (Revolve core to make Release Liner a little tight)
3. Set pressure lever to the proper position according to your laminating condition.
4. After pressing the button, choose and
set proper speed by using the and
button.
5. It is when ready is dispalyed
on the screen and beeps three times.
6. Turn on the take up device and set
the proper film tension by pressing
the
RUN "button. Lower tension
would make better operation.
7. Center the document on the table.
For ease and convenience set the
document guides in position
8. Press the
RUN "button and "take up motor" at the same time.The liner and film
will roll at the same time.
9. When lamination is completed, press the button.
10. Set pressure lever at the "OPEN" mode.
11. Turn off the power switch.
10. USING CROSS CUTTER
1. After lamination, move the cutter
approximately to the center of the
completed application at the desired point
of detachment (Figure 1).
2. Grasp film with one hand, press the cutter
downward into the application and slide it
first to one end of the application, then to
the other end to complete the cut.
(Figure 2 & 3)
Figure 1
Figure 2
Figure 3
The cross cutter is located on the rear exit table of the machine.