Filter
Top Products
RSC Series
109
10. USING CROSS CUTTER
Figure 1
11. LOADING FILM
Royal Sovereign films are wound with the adhesive side facing the inside of the roll
(adhesive in).
Figure 2
Figure 3
Figure 1
Figure 2
Figure 3
Figure 5Figure 4
The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to
the center of the completed application at the
desired point of detachment (Figure 1).
2. Grasp film with one hand, press the cutter
downward into the application and slide it first to
one end of the application, then to the other end to
complete the cut (Figure 2 & 3).
Loading films to the top and bottom film shafts:
(See page 5 for assistance with parts identification.)
1. Remove the top and bottom film shafts from the
machine.
2. Load a roll of pressure sensitive film to the top film
shaft (Figure 1). Center the film and tighten the core
screws (Figure 2).
3. Load a roll of mounting film or roll of craft paper to the
bottom film shaft. Do not tighten the core screws at
this time.(Figure 3)
Note: Please see the direction of the film on the top
and bottom shafts.
4. Load the top and bottom film shafts onto the machine
(Figure 4 & 5).