Filter
Top Products
RSS, RSR, RSH Series
1615
Figure 1
1. Lay the decaled image face down on a flat surface.
Carefully peel back and put a crease along the edge of
the release liner (Approximately 1 in or 25mm, Figure 1).
2. With the image facing up, align the image onto the
board. Press firmly from the center out (Figure 2).
3. Adjust the pressure lever to ensure the proper opening
(Figure 3).
4. Flip the image over the upper roller and hold on to the
release liner (Figure 4).
5. Depress the foot pedal once, and then let it go while
slowly pulling the release liner as the board enters the
main roller nip (Figure 5).
Depress the foot pedal once again when the board has
completely exited from the rear of the unit.
Trim the board if necessary.
Installation of the Front Feeder Option (Includes 2 brackets, one
spindle, and mounting hardware).
1. Install the Front Feeder to the inside of the front frames using
four 1/4" (M6) hexagon bolts on each side (Figure 1)
Installing the Rear Rewinder Option (Includes motorized winder,
bracket, one spindle, and mounting hardware).
1. Remove the left and right covers by using a screwdriver
(four screws on each side cover) (Figure 2 & 3).
2. Remove the lever knob screw and lever (Figure 4).
3. Remove the rear cover by removing all
10 screws (4 top, 4 bottom, and 1 on
each side) (Figure 5 & 6).
4. Disassemble the power switch bracket and place the left
rewinder outside of the frame; fasten with round head
3/16"(M5) screws (included in the option kit). Then, reinstall
the power switch bracket (Figure 7).
5. Install the right rewinder on the outside of the frame and
connect the motor wire connector to the rear wire
(Figure 8 & 9).
6. Reinstall the rear cover.
7. Reinstall the side covers.
8. Reinstall the lever knob and screw.
Figure 1
Figure 2 Figure 3
Figure 4
Figure 5 Figure 6
Figure 7
Figure 9Figure 8
Figure 2
Figure 3
Figure 4
Figure 5
13.3 Mounting
14. INSTALLATION OF FRONT FEEDER and REAR
REWINDER OPTIONS
NOTE: Below options are to be installed by an authorized
RS reseller.(These options are available for the RSH-1650.)