RuggedCom RSG2200 Switch User Manual


 
2
2008 RuggedCom Inc. All rights reserved Rev105
Federal Communications Commission Radio
Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference on his own expense.
Trademarks:
Ethernet is a trademark of Xerox Corporation
RuggedRouter and RuggedRated, are trademarks of RuggedCom® Inc.
CAUTION
This product contains a laser system and is classified as a “CLASS 1 LASER PRODUCT”
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure. This product contains no user serviceable parts. Attempted service by
unauthorized personnel shall render all warranties null and void.
Changes or modifications not expressly approved by RuggedCom Inc. could void the user’s authority to operate
the equipment.
Should this device require service see the “Warranty and Service” section of this guide.
IMPORTANT
The RX1000 family of products should be installed in a restricted access location where access can only be
gained by service personnel or users who have been instructed about the reasons for the restrictions applied to the
location and about any precautions that shall be taken; and access is through the use of a tool or lock and key, or
other means of security, and is controlled by the authority responsible for the location.