Runco CL-500 Projector User Manual


 
5. Menu
User’s Manual
21
ENVIRONMENT Setting Page
In this Menu, the global settings for the projector can be made.
There are 5 Menu Items: DEFAULT — LAMP TIMER — BACK LIGHT — AUTO OFF — LAMP HOURS.
1. DEFAULT: Load the default value of current input source.
2. LAMP TIMER: Resets the lamp timer. This should only be done after the lamp has been replaced.
3. BACK LIGHT: Turn on/off the Power ON Indicator.
4. AUTO OFF: Set the auto shutdown timer. The setting timer is from 10 minutes to 3 hours.
5. LAMP HOURS: This displays the number of hours the lamp has been used (the useable lifetime of the lamp is 1500
hours). If the lamp hours exceed 1500, a warning message will be displayed on screen; when this happens, contact
your Runco dealer for a new lamp.
INSTALL Setting Page
This menu contains items necessary for installation.
There are 4 Menu Items included: LANGUAGE, MIRROR, KEYSTONE and SCREEN.
1. LANGUAGE: There are 3 languages that could be selected for the menus: English, French and Spanish.
2. MIRROR: The projector could be installed on a ceiling or behind a screen, or with one or more mirrors. There are
four settings:
FLOOR FRONT
CEILING FRONT
FLOOR REAR
CEILING REAR
3. KEYSTONE: Corrects for trapezoidal distortion as a result of the angle of projection (-12 ~ +12). This can correct
for up to ± 12 degrees of offset.
4. SCREEN: Select the right aspect ratio for your screen.
4 X 3
16 X 9