Runco CL-710 Projector User Manual


 
6. Additional Information
Runco CL-710/ CL-710LT User’s Manual
27
6. Additional Information
Warning Message
Replace the Lamp (Contact your Runco Dealer)
It is normal for lamp to be darker when this unit
has been used for a period of time.
" Lamp life is expired ! Please change a new lamp.
And reset the lamp timer" message will be
displayed for 30 seconds on the screen if the lamp
has operated for 950 hours.
" Please change the lamp, Lamp will exceed its
lifetime after (hours):" message will be displayed
on the screen for 30 seconds for each time turning
on, if the lamp has operated for 980 hours. And
the number will count down continuously.
"Please change the lamp !" message will display on
the screen all the time and the POWER LED will
blink in orange and green sequentially if the lamp
has operated for more than (1,000) hours.
The power will turn off automatically after 10
minutes.
1. Loosen the screw of
front lamp cover
2. Take off the front lamp
cover.
3. Loosen the two
screws of lamp
module.
4. Pull out the lamp
module horizontally.
5. Insert the new lamp
module into this
projector
horizontally until it
is securely in place.
6. Tighten the two screws
of lamp module.
Lamp life is expired !
Please change new lamp
And reset the lamp timer
Please change the lamp !
Lamp will exceed its
lifetime after (hours):
Please change the lamp !
1
2