Filter
Top Products
10 Russound BGK3 iBridge Power Dock Kit Installation Manual
BEHAVIOR OF LEDS
Activity LED (for BGDA and BGCA)
Solid off - no Home Plug network activity detected.
Off, periodically blinks on - No home Plug network received. The device is
transmitting Home Plug packets.
Solid on - Home Plug network traffic was received, but there is currently no
Home Plug network traffic.
On, periodically blinks off - HomePlug network traffic was received, and
there is currently communication (either transmit or receive) on the Home Plug
network.
Binding LED (for BGDA and BGCA)
Solid off - Not bound to another device. This is the default state before
binding, and can be reset to this state by holding the binding push button
down for 10 seconds. In this state, the device is communicating with the
standard "HomePlug" password, and can then be upgraded using upgrade
software and a HomePlug Ethernet bridge.
Blinking - Pressing the binding push button will cause the device to enter the
binding process. After this, the LED will either slow or fast blink depending on if
the device was the first device to join the network.
Fast blink - attempting to bind to another device.
Slow blink - waiting for another unit to bind to this device. This may be a newly
created network, if this device was not already bound to another device.
Solid on - the device has been bound to another device.
Docked LED
BGDA solid off - No iPod is inserted in the Dock.
BGCA solid off - cannot detect an iPod attached to the remote BGDA. This
could either be the case where there is no iPod docked, or the iPod is docked
and something is preventing the devices from connection (check binding, and
if iPod is correctly inserted in the Dock.
BGDA solid on - an iPod is inserted in the Dock.
BGCA solid on - an iPod is connected to the BGDA, and the BGDA is
communicating with the BGCA.
BGDA LEDs on front panel
BGCA LEDs on front panel