Guided Tour -
PowerBrite Pro7 Front Panel
1: Light switch - Use this to turn the fluorescent light in the slide-out
drawer on or off. When on, the status light inside this switch is lit red.
2: Outlets switch - Use this to turn the rear-panel outlets on or off.
When on, the status light inside this switch is lit red.
3: Voltmeter - This ten-stage LED meter shows the amount of voltage
in the electrical signal being received by the PowerBrite Pro7.
WARNING: Severe voltage swings can cause damage to connected
equipment. If you see the voltmeter changing drastically or rapidly,
disconnect the Pro7 until the source of the problem is identified.
4: Slide-out drawer - Contains the Pro7’s fluorescent light, clear plastic
diamond lens and back-lit inlay. Use both fingers to press gently on the
two “Push” squares on the front and the drawer will slide out towards
you. Use the Light switch (see #1 above) to turn the light on or off. The
light uses a standard 4 watt fluorescent bulb which is readily available at
most hardware stores or electrical suppliers (see page 10 in this manual
for information on how to change the bulb). To lock the drawer back into
place, gently slide the drawer back in (again using both fingers on the
“Push” squares) until it clicks. See the inside back cover of this manual
for information about our “Neo-Rack” service which allows the inlay to be
replaced with a custom facility logo or name.
5: Ammeter - This ten-stage LED meter shows the amount of current
being drawn by equipment connected to the PB Pro7. WARNING:
Severe current swings can cause damage to connected equipment.
If you see the ammeter changing drastically or rapidly, disconnect the
PB Pro7 until the source of the problem is identified and repaired
.
6: Unswitched convenience outlet - This 3-pin AC outlet is active
whenever the PB Pro7 is plugged in, regardless of the setting of the
Outlets switch (see #2 above).
7: Circuit breaker- This circuit breaker will trip whenever the total load
on the PB Pro7 (all rear-panel switched outlets plus the front-panel
unswitched convenience outlet) exceeds 15 amps. To reset it, unplug
one or more devices so as to reduce the load and gently press the circuit
breaker in until you hear it click.
7
85
95
105
110
115
117
120
124
127
130
LIGHT OUTLETS
UNSWITCHED
15 AMPERES
SAMSON
PowerBrite Pro7
AMMETERVOLTMETER
PUSH
PUSH
SAMSON
1.5
3.0
4.5
6.0
7.5
9.0
10.5
12.0
13.5
15.0
5
1
2
3
6 7
4