Filter
Top Products
11
ENGLISH
10 Inch Long Throw Transducer 120 Watt Amplifier
+4 INPUT
-10 INPUT
DESIGNED AND ENGINEERED IN
THE UNITED ST
AT
THE UNITED STATTHE UNITED ST
ES BY SAMSON
www
.samsontech.com
CAUTION
S/N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
115-230 vac ó 50Hz/60Hz 175W
POWER
RATING
RESOL
V MONIT
RESOLV MONITRESOL
ORS CAN A
EXTREMEL
Y HIGH SOUND
EXTREMELY HIGH SOUND EXTREMEL
PRESSURE LEVELS.
USE CA
PRESSURE LEVELS. USE CAPRESSURE LEVELS.
OR HEARING DAMA
S/N
OR HEARING DAMA
S/N
GE MA
10
-27
-21
-15
-9
0
5
100
1K
10K30K
FREQUENCY (Hz)CROSSOVE
R
dBr
RISK OF ELECTRIC SHOCK
DO NOT OPEN
115-230 vac ó 50Hz/60Hz 175W
POWER
RATING
10
-2
7
-2
1
-1
5
-9
0
5
100
1K
10K30K
FREQUENCY (Hz)CROSSOVE
R
dBr
FROM MIXER
R
L
Connecting to t
he Resolv120a Subwoofer
RESOLV 50a with Mono Sub
Adding a subwoofer (and extended low frequency response) to your RESOLV 50a system is easy using the RESOLV 50a’s
LINE LEVEL inputs. Below is a typical system set-up using the RESOLV 120a with a mixer and a pair of RESOLV 50a satellite
speakers. For a detailed wiring diagram, see the section “RESOLV 50a Connections” on page 12. Follow the steps in the
diagram below to set up your system:
• Lower your mixer’s master outputs to all the way off.
• Connect the mixer’s Left output to the RESOLV 120’s LEFT PREAMP LEVEL INPUT and the mixer’s Right output to
the RESOLV 120’s RIGHT PREAMP LEVEL INPUT. Now connect the RESOLV 120’s LEFT PREAMP LEVEL OUTPUT to
the input of the left RESOLV 50a, and the RESOLV 120’s RIGHT PREAMP LEVEL OUTPUT to the input of the right
RESOLV 50a.
• Run an audio signal (like some music from a CD) through your mixer and raise the level to a comfortable
listening level.
• Now adjust the SWEEP control to the desired frequency. A good place to start is about 70 Hz. You can also use
your ears by adjusting the SWEEP control to the frequency that sounds good to you.