Filter
Top Products
52
Control codes
Hexadecimal codes
Function
<FS> 1C Control peripheral device #1
immediately.
<EM> 19 Control peripheral device #2
immediately
<SUB> 1A Control peripheral device #2
immediately
<ESC> “d” n 1B 64 n Partial-cut command to the
auto cutter.
<CAN> 18 Cancel last line & Initialize
printer immediately
<DC3> 13 Deselect printer
<DC1> 11 Set select mode
<RS> 1E Beep the buzzer
<ESC> “@” 1B 40 Initialize printer
<ENQ> 05 Inquiry (Status inquiry)
<EOT> 04 Near end status inquiry
<ESC> “?” <LF> <NUL> 1B 3F 0A 00 Reset printer hardware
(Perform test print)
<ESC> “8” n1 n2 1B 38 n1 n2 Registers a logo pattern
<ESC> “9” n1 n2 1B 39 n1 n2 Prints a logo pattern
53
B. Connectors
䧎 When the Dip Switch is “ON” on the Serial Interface Board,
DTR and RTS are connected each other.
SRP-350/SRP-350S Connector
( Serial Interface )
SRP-350P Connector
( Parallel Interface )
SRP-350U Connector
( USB Interface )
Interface Connector
Drawer kick-out
connector
Power supply
connector
RS-232 Ver.2ON
Interface Connector
Drawer kick-out
connector
Power supply
connector
PARALLEL Ver.2
USB
USB Connector
Drawer kick-out
connector
Power supply
connector
Ver.2