Filter
Top Products
Action 4
to Cooling mode, because the
internal temperature of the
projector has increased beyond
the maintenance limit.
* Cooling mode: The fan speed has increased and the projector lamp has
been changed to ECO mode.
Check whether the ventilating hole of the projector is blocked.
Check the air filter and clean if blocked.
Check whether the surrounding temperature of the projector is higher
than the standard temperature range of the projector.
Cool the projector sufficiently and operate it again.
Action 5
If the internal temperature of the
projector increases higher than
the limit, it is turned off
automatically.
Check whether the ventilating hole of the projector is blocked.
Check the air filter and clean if blocked.
Check whether the surrounding temperature of the projector is higher
than the standard temperature range of the projector.
Cool the projector sufficiently and operate it again.
If the same problem occurs continually, contact your product distributor or
service center.
Action 6
The lamp
malfunctions after power
turns off
abnormally or after
powering on right after
turning off the projector.
Turn the power off, wait for a sufficient amount of cooling time and then
turn the power on to operate. If the same problem occurs continually,
contact your product distributor or service center.
This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan
may cause noise, which does not affect the product performance and is part of normal operation.
Rear Side
1. PC OUT port
2. AUDIO OUT port
3.
RS-232C port (For service input
terminals)
4. [AV IN] R-AUDIO-L Input port
5. [AV IN] VIDEO Input port
6. [AV IN] S-VIDEO Input port
7. [PC IN1,2] PC Input port
8. [PC IN1,2] AUDIO Input port
9. Remote Control Signal Receiver
10.POWER Input port