Filter
Top Products
2-19 Installation and Connection
2-19 Connecting to a Network
This product can use network functions. Refer to the following Network connection method.
2-19-1. Connecting to a Dynamic IP (DHCP) Network
You can attach the projector to your network through a modem that uses DHCP (Dynamic Host Configuration Protocol). When
you use a DHCP modem, the modem automatically provides the IP address, subnet mask, gateway, and DNS server values that
the projector needs to access the network.
To connect to a DHCP network, follow these steps :
1. Connect the modem cable between the modem port on the wall and the external modem.
2. Connect a LAN cable between the external modem and the wired or wireless IP router.
3. Connect a LAN cable between the [LAN] port on the back of the projector and the wired or wireless IP router.
4. Turn the projector on and press the [MENU] button.
5. Select <Setup> → <Network> → <IP Setting> → <Automatic>.
6. The projector automatically acquires the IP address, Subnet mask and Gateway.
To use the network function, <Network> must be set to <On>.
If the IP address allotment from the DHCP server fails, turn off the external modem for more than 10
seconds, restart the modem, and then retry the connection.
For instructions on the setup and connection of the external modem and router, refer to the user manual for each product.
You can connect the LAN cable from the modem directly to the projector, You do not need a router.
You can not use a manual connection-type ADSL modem because it is not a DHCP-type device. Make sure to use an automatic
connection DHCP ADSL modem.