Filter
Top Products
[Appendix 3] Factory Reset
1. Default setting after factory reset
- Activate DHCP mode
- Local Port: 9100
- Inactivity Time: 0
- Speed
SRP-770II, SLP-T400: 230400 bps
SRP-270, SRP-275, SRP-350, SRP-350plus, SRP-370, SRP-372: 9600 bps
2. How to rest
1) Turn off the printer
2) Turn on the printer while pressing Function Key
[Note]
Press Function key 3 more seconds after turning on the printer.
3) Wait 10 seconds until new IP address is allocated to the printer.
- The IP address will be allocated automatically under DHCP mode.
[Note]
- DHCP Network environment
Connect to web-server with newly allocated IP address.
Check new IP address by pressing Function key
- Static IP Network environment
The IP address will not be allocated automatically.
Set up Static IP with Configurator utility.
4) Print Network setting information by pressing Function key
- Connect web-server to change any network setting
[Note]
Check if the baud rate of the printer is set same as below.
SRP-770II, SLP-T400: 230400 bps
SRP-270, SRP-275, SRP-350, SRP-350plus, SRP-370, SRP-372: 9600bps