Filter
Top Products
Rev. 1.07
- 12 -
SRP-350
1-4 Setting the Dip Switches
1-4-1 Serial Interface
SW Function ON OFF Default
1 Auto Line Feed Always enabled Always disabled OFF
2 Reserved - - OFF
3 Handshaking XON/OFF DTR/DSR OFF
4 Word length 7 bits 8 bits OFF
5 Parity check Yes No OFF
6 Parity selection EVEN ODD OFF
7 ON
8
Baud rate selection Refer to the Following Table
OFF
DIP switch Setting 1 Function
Transmission speed SW – 7 SW – 8
9600 baud ON OFF
19200 baud OFF OFF
38400 baud ON ON
57600 baud OFF ON
Baud Rate Selection
SW Function ON OFF Default
1 Emulation STAR EPSON OFF
2 Internal bell control Internal bell disable Internal bell enable OFF
3 Auto Cutter Selection Disable Enable OFF
4 Busy Condition Receive Buffer Full
- Offline
- Receive Buffer Full
OFF
5 OFF
6
Select Print Density Refer to the Following Table
OFF
7 Near End Sensor Status Disable Enable OFF
8 Reserved - - OFF
DIP switch Setting 2 Function
Print Density SW - 5 SW – 6
1 ( Light ) ON ON
2 OFF OFF
3 ON OFF
4 ( Dark ) OFF ON
Select Print Density